Augvape Intake Dual RTA Review

And for the appetizer, I prepared something more interesting for you. Augvape has replenished its product range with a new tank, and even which one. Surely you remember Intake RTA – a single-spiral tank that has found numerous fans and has become a worthy representative of the single-spiral non-spill segment. So the developers, together with the ideological mastermind of the Mike Vapes series , decided on a new release. Moreover, now the intake has become double-stranded. 

Augvape Intake Dual RTA 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
Case material: stainless steel 
Atomizer type: RTA 
Capacity: 4.2 / 5.8ml 
Diameter: 26mm 
Height: 46.4mm with drip type 
Connector: 510, pin is gold-plated 
Weight:unknown 
Color: see photo below 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
Options
– Intake Dual RTA 
– pre-wired spirals 2pcs 
– cotton 
– Allen key 
– spare origins 
– spare screws 
– spare glass 
– coil trimming tool 
– user manual 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
Our guest’s exterior is completely recognizable – it’s absolutely the same tank as and his ancestor. The same “risks” on the lid, the familiar blowing adjustment ring with embossed engraving. Unless it seems that the base has become a little thicker, which naturally cannot but rejoice. By the way, the diameter also increased.
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
The drip type is probably 810 landing, it is quite high, while the first version had a pre-installed instance much lower. The lid is uncorked with a half-turn, under it of a size-sized filling holes. 

Under the cover is a traditional tightening ring with a swivel ring. As you rightly guessed, the continuity of generations is preserved – we again have a shed. 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
The capacity is average, but the complete bubble will increase almost one and a half times. 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
The deck was not really shown to us, but even by such renderings it definitely reminds something))) 
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
It is non-structural, designed for two spirals, the fixation of the latter is correct. The holes in the racks are responsible for lateral airflow – that’s what they would like to study first of all. Well, apparently not fate. Probably there will be perforation.
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...
There is plenty of room left for cotton; limiters are available. However, the cuts in the wells seem small for two spirals. 

The pin is gilded and protrudes enough. 

The price is $32.99
Augvape Intake Dual RTA - plus one spiral and familiar exterior ...

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available:Augvape Intake Dual RTA
Hot Sale Recommendation:

Eleaf Rotor Sub ohm Tank

Damn Vape Diamond MTL RTA

OBS Land Vape Pod System Kit

Smok RPM40 Vape Pod System Kit

Geekvape Aegis X TC Box Mod

Vape Wholesale & buy Electronic Cigarettes online in Bulk. 2m*1i9y0a7j*

Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html

Starter-Kits:https://www.ave40.com/starter-kits/disposable-pod-system-kits

Vapefly Holic MTL RDA Review

After a short break, Vapefly is back in business. And the most pleasant thing for me personally is that they again began to work for what they can do, namely mtl atomizers. I think no one will argue that in the budget segment of this direction, they earned a decent credit of trust from brand fans. Therefore, with genuine interest, I propose to start an acquaintance. 

Vapefly Holic MTL RDA
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...

Case material: stainless steel Atomizer type 
: RDA 
Capacity: small 
Diameter: 22.2mm 
Height: 41.7mm with drip Connector type 
:510, pin gold-plated 
Weight: unknown 
Color: see photo below 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
Package contents 
– Holic MTL RDA 
– pre-wound helix 2pcs 
– cotton 
– beauty ring (probably 24mm) 
– key screwdriver 
– hex key 
– spare oring pin 
– spare screws 
– jib pin 
– spare side blower nozzles 
– user manual 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
I can’t keep quiet about picking – besides the owner will have everything to start with, so you’ve put something here for your soul. Here I was always interested in the question – for such a modest price tag in a box there is so much of everything, so what prevents other manufacturers from doing the same.
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
The exterior of our guest is quite decent – no vulgar decor is observed. Yes, the shape is very nice, even if the drip and tall with it. But offhand, we can say that the domed part is massive for a reason – it will be responsible for heat dissipation, and this, as you know, is a sore question in this segment. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
Everything is standard with colors – the choice, as always, is decent from the start. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
Drip type 510th, he made of Delrin. It is a bit strange that there is no extra in the box this time. He sits down in the dome, on the sides of which are located the ventilation adjustment holes.
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
And the location of the latter is asymmetrical – this is what we saw in their RDTA. It is a working constructive blowing, providing decent variability. On both sides, the holes were cut by the orings, which would prevent air from the outside in advance. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
But the deck is already familiar to us, to the pain in the fingers, thank God, only the hands. This is me to the fact that the users of this constructive mass, since such a construct is unchanged for several new products of the manufacturer. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
All the same two racks for correct fixation of one spiral. On the sides there are notches for centering the coil. For the airflow there is a small nozzle at the bottom and two on the sides, peeling at an angle from the deck.

As you remember, the latter have always been adjustable, so they did here. However, constructive changed, as for me, for the better. Now inside the half-turn rods with holes, with a “hint” applied to the slits for adjustment, therefore it will be possible to adjust the blowers identically on both sides. True, it seems to me that the air flow on the covered holes will smear a little, but here it is necessary to try – probably, the error will be insignificant. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
The bath is not the deepest, and the developers offer us to bury the drip, each time removing the entire dome and knocking down the blowing setting. Well, it does not matter because the profile use of such gizmos on the skonk mods. Especially for this provided the appropriate pin. 
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
Both pins are gilded and perform sufficiently.
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...
The price is $ 27.99.
Vapefly Holic MTL RDA - it became more interesting both from the inside and from the outside ...

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available: Vapefly Holic MTL RDA
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Voopoo Alpha Zip TC Kit

Voopoo Drag 2 Platinum 177W TC Box Mod

Voopoo Drag Nano Kit

Smok Novo 2 Pod System Kit

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html

WOTOFO Bravo RTA Review

The company Wotofo even calmed down a little, but still continues to actively produce new items. The first rumors about the new Bravo RTAappeared quite a long time ago, but officially the tank was presented to the public only a couple of days ago. I propose to look at the new flagship and try to draw some conclusions about its competitiveness. 
Bravo by Wotofo -
For the most part, I like Wotofo products . It should be clarified that now I’m talking about atomizers, because the situation with the boxes from this manufacturer is incomprehensible. Until recently, my favorite was Troll RTA , then SMM replaced him in this post , who had to give up his place to Bravo. Seriously, tank, IMHO, looks very cool. 

Vape Wholesale Supply,Vape Wholesale China – AVE40
Bravo by Wotofo -
I was already so tired of patterned solutions with tanks, that any unusual detail impresses me. In the case of the hero of this review, I was attracted to the corrugated parts of the body. Having tried to imagine a tank without this feature, I realized that it is thanks to them that it looks so stylish. By the way, for me, the black version of the tank overshadowed all the others. Yes, and the logo on the dome adds originality to the appearance 🙂 
Bravo by Wotofo -
Dimensions : 

Height – 48.9 mm. 
Diameter – 25 mm. 
Weight – 40 g. 
Bravo by Wotofo -
Specifications : 

As is often the case, releasing a new device, the company immediately announced its uniqueness, advancement, etc. I agree that BravoInteresting enough, but I haven’t found any super innovative solutions. Just a good bachek with very good chances of success. I have an ambiguous first impression about the serviced base of this atomizer. Yes, everything looks interesting and fresh, but I will not believe in practicality and convenience until I personally try it. 

Top Vape Tanks, Vape Atomizer, Clearomizer Online | Ave40
Bravo by Wotofo -Bravo by Wotofo -
Everything works as follows – each rack has two screws and one fixing platform. First, you unwind the middle screws, and then, by unscrewing the extreme, lower the pad itself. Having established spirals, by the same principle you lift the platform – that’s all. As for me, everything is quite confusing and it will not come out right away. By the way, the system reminded me of what OBS offered in its drips.
Bravo by Wotofo -
There is nothing difficult to find in the blowing system, even with great desire. An interesting point I would call the fact that the nozzles in the base itself are made a little at an angle. I wonder how it will affect the result. At one time, I rather actively used the Troll RTA . What I liked most about this tank was the combination of compactness and a spacious liquid tank. The tank contained as much as 5 ml, while competitors rarely went beyond 3-3.5 ml. In Bravo , I like the situation even more.
Bravo by Wotofo -
By default, the glass is set to 4.5 ml, but if you use the additional “blown” glass, the indicator will increase to 6 ml. At the same time, the tank does not look like a huge, pot-bellied monster. With the refueling system they decided not to subtilize. Thanks to the knurling on the case, it will be possible to remove the top cover even previously with a very good wetting of the hands. 
Bravo by Wotofo -

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available :WOTOFO Bravo RTA
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Justfog Compact 14 Starter Kit

Rincoe Mechman Mesh Kit

Voopoo Drag Nano Kit

Voopoo Drag Baby Kit

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html